ANeonRider
-
Content Count
4,457 -
Joined
-
Last visited
Everything posted by ANeonRider
-
12" RL-p, 1.21cu. ft box sealed, amp settings?
ANeonRider replied to beejohn's topic in SoundSplinter
Do you know how many volts are outputted from the rca adapter? -
12" RL-p, 1.21cu. ft box sealed, amp settings?
ANeonRider replied to beejohn's topic in SoundSplinter
What headunit? -
Came painted, painted w/logo, or inodized.
-
RL-p's.
-
To tell ya the truth, maybe only 5 decks ever made do not clip (well, probably more, but you get what I am getting at). Most of them cost much more than $600. Overemphasing a group of frequencies is audio homicide as well.
-
Benefits of a larger enclosure? Ability to extend lower. More efficient, lower power handling. Flatter response.
-
Again... struts have no bearing on ride height (unless they are air or coilover-type). Springs are what keep the vehicle suspended, and struts/shocks are what keeps the springs from bouncing all over the place.
-
Deck may not clip, but the amp will.
-
Read the gain setting tutorial please.
-
You don't have to take the gasket off. You can flip it around, or leave it how it is.
-
Should invert one of them
-
Common chamber?
-
ahh, wasn't sure what was adjustable on that thing
-
Besides incorrect tire pressure, incorrect toe alignment will also cause pre-mature wear.
-
wow! I got them in today. Now that is faster than I expected. Very nice decals too!
-
Isobaric, always wanted to do that.
-
Downloaded the WHOLE Neil Young discography. Wow.
-
How about we don't make any "assumptions" and let Mike tell us what is going on?
-
It isn't
-
8/2 = 4ohms. You don't only need to use the left output, that is all I am saying, you can run both subs like picture #2, but it is more of a wiring headache.
-
Nope... Ok, the two outputs are internally bridged otherwise known as internally paralleled. They have the same signal going to them. So... if you hook up one dual 4 ohm sub (wired in series) to the left output, and another 4 ohm sub (wired in series) to the right output, the amp will see a 4 ohm load. In your case, the amp puts out 850W into 4 ohms, and therefore, each sub will have 425W available to them.
-
It has two sets of outputs, but they will be bridged internally, so if you are running two subs, you wire each sub to an output. You will have to wait until the fall before anymore RL-i 8" subs are made, Mike is in the process of re-tooling right now.
-
Welcome!
-
http://aneonrider.com/Misc%20Files/WineOpener.wmv If anyone decides to spread this around to the whole internet... I will kill the link quickly.
-
look on ubid for that Kicker amp, might be on there.