desiredfaith

Alright right now i have a FI Q12" running 1000 RMS@ 1 ohm (with knob at 10% power) thing hits harder then hell right now, in the past iv always used sealed boxes and when i got this one i got a ported to see what the hype was about I want to get a sealed again but if i do will i lose those super deep lowes or is it the sub itself that makes them. (basicly i want to know will i get the deep lowes with a sealed)

Alright, as of this moment have that sub running from a crunch pzi100.1 @ 1 ohm. Sounds decent and does not overheat (its a hold over till i can afford the sundown) also im having a hard time trying to find some with a sealed box that will trade me for my ported since i enjoy SQ more

so should i put it on 4 ohm 1000 rms or 1 ohm 1000rms. only difference i know is that 1 ohm draw more power

honestly i don't doubt it ha.. i saw it and i was like OMFG no way... so i drove 40 min there and tested it with a ohm tester and both coils checked clean. hooked it up to my comp amp (has a 120 RMS 4 ohm sub output) to test its flexability and still flawless its ability to flex max out and in as fast as possible with eas. So my guess it he had alot of money or this thing was jacked... either way i made out with a smile

Ok so even if the sub is running lower then 1 ohm because the amps 1 ohm its not going to draw different resistance. I wan't to be 100% flawlessly sure before i hook it that way and not blow out the amp like iv done before (used to have alpine type R double 2 ohm)

Alright, for the last year and a half iv been planning on getting the 10" SSD till recently i found a steal of a deal on craigslist for a 12"Q for 100 bucks duel 1.75 ohm coils Currently i have it in a ported box with 600W RMS running to it at 4 (3.5)ohms. My question is if i run it with both positives and negatives together insted of series and it turns into 1 (.87)Ohms will it be too much being alittle under 1 ohm load? if not then what would be a good amp to push it at 1 ohm 1000 RMS? My plan in the end is to get a sealed encloser with 1000 RMS @ 1 ohm since i like sealed better and getting a 1000RMS 4 ohm amp is expensive as hell.. thanks for helping an taking the time.