shotta76

I was reading the instructions, but I don't quite understand them. I would really appreciate if somebody would explain how 2 do this.

Thanks you guys for all your help

Thanks man.

I have 2 D2 18inch Btl's and 2 SAZ 3000ds I need to know how to wire the subs down 2 ohm, because i'm strapping the amps together.

The Mechman alt I have does 267 amps full tilt

I have twelve inch btl and its not going to match the output of two 12 or 15 inch L7's. It doesn't have the cone area to do so. It an unfair match up your placing 113.1 sq inches of cone area against roughly 288 sq in or 450 sq in. I think the 18 inch btl could out due the 12 L7's on the same amount of power.

I'll second that

If your looking for a single sub setup that can crush a dual w6's I would have to say go with a BTL

Ill do that when my new alternator comes in.

I just got my new fi 12 inch btl intalled. All I can say is wow. I heard that the it gets super low, but I can't believe how hard the bass drops on a single 12. I have a 2.5 cubit foot port box tuned to 32 hertz, Hifonics brutus 2608 amp, and Kinetic Hc 2400&1400. This is all in a 2007 FJ Cruiser. This woofer takes a beating like a champ.

That 4 gauge wire just goes to rear battery. I have 0 gauge going to the amp from rear battery the fuse is back there too. No I haven't tried turning the box around, but it gets incredibly loud they way it is. I might try it one day though.

that's my set up

Yes my main battery is the hc2400 and the back is a 1400

I post some pics tomorrow

Hifonics amps aren't all that bad if you can't afford sundown or rockford fosgate or any other expensive amp. The new hifonics amps actually do rated power.

Most definitely the Q can handle the rated power plus a little bit more fully loaded. I have heard the w6 in person, but I have not heard the Q. I was able to destroy it with my two 12 w3's. I think that the Q would satisfy your needs. I don't think that the w6 is in the same class as the Q either. I think that it is better matched up with the w7. I'd go with the Q

I would go with the 2 12's more cone area.

I should be getting my 12 inch BTL in about a 1 week and half. I'm going to be powering it with RF T2000BD. Just wondering if I could a real life demo before I set mine up.