ManzKea

Lol. Dang.i can see where you’re coming from. Maybe if it does something out the ordinary. you can bring it up. Hair trick, rattle the windshield wipers. Etc.

Can’t wait to see how it sounds like. I know it’s on the smaller side due to the fact the guy didn’t wanna give up too much bed

Oh and that’s for both subs? Interesting.

How big did you go in the sealed section

Looking sweet

Is that so? Yea I guess I am using that subwoofer mindset. And i never really was interested in trying out something different on my mids because one, I gotta buy a few to replace the stock speakers. So if i didn’t like it I’d have to re buy the same speakers in the 4ohm load lol. I also wanted to maximize the rms rating of the speaker. So I figure 2 speakers at 125 each would be more louder than 4 at 62.5.

Well I was wanted to wire down to 2ohms to get the most out the amp. And I didn’t wanna buy more speakers to get the ohm load I was wanting. Shipping to Hawaii sucks lol. But idk I haven’t been around the block as much as some of the people here so I’m in that boat of wiring low to get the most out the amp

I like em. I used em in three vehicles so far for Sounds and i enjoy it. All vehicles had one up front and one in the rear. I went with these because I’ve read optima wasn’t all that. I used to run optimal prior then started getting more into Sounds and saw on forums people saying it’s overrated or whatever’s.

What if I was to make it like yours. How the sub is facing the plexiglass glass. And I make it a little tunnel into the cut out? I guess that’s like a 6th order idk. Would that little tunnel make a drastic difference ? And whats eats your projection on the out out of the box? What kind of ratio did you design it around

Oh ok good to know. Hearing that from someone more experienced.

It’ll be sealed. Just saying thought there could be some cancellation due to the sub and port being larger than I could cut the hole.

Yea I’ve never done a band pass Box before so I wanted to keep it ported. But will there be cancellation ? Because I’ll try to make the hole big but it wont be as big as the sub or port. Like a trunk wall. It’ll just be an opening with with part of the sub and port being blocked.

Nice. You work fast

How do you feel about that ? I’m wanted to do a full cut out to make a regular ported Box. But the 4th order seems more effective since it’s a direct shot of out put into the cab.

Nice can’t wait to see it completed. Was that actual car paint y’all used to paint it ?

Sexy pods

Oh man the evils want the save on the larger side lol. Unless you trim it down a bit.

Oh damn back at it again? So soon!? Lol. And perfect timing I’m looking into doing a blow through for my single cab ranger. I’ll be tuned in my friend

So after 4 months of waiting I finally revived these baby's. It's such a relief and a long wait coming lol. Can't wait to pick up a taramps 8k to push these. And build my box also. These things are super heavy and beffy and beautiful. Really stiff. unfortunately i didnt didn't receive my tshirt or any stickers for that matter that's a bummer I was looking forward to that sick black shirt. And I took out the wooden things that help keep the sub protected during shipping.

No we had to reconnect it to the meter again. I’ll kept going off and on

Another vid. Different frequencies and it’s a regular song. Towards the end the apm froze so apologies for that don’t know why tho

Welcome

Not sure how to take it. Lol sorry don’t know where you’re getting at. Good? Bad? Irrelevant? Lol

I didn’t have a bass sweep on hand to see where I peak. but that was the song.