iml2001ser

looks good

Very nice

Looks sweet

looks clean

where you find that box that has a face down port forward box at mike?

Yea the fronts do need more power, So basically that would be a 3 way setup. Cant you jus run a active setup then, since i can change my deck setting to 3 way, n ditch the crossovers that came with the components.

Thanks guys, now i need to replace the 300/4 to 100.4. Hopefully it will fit runnin out of space. lol

Hey Folks this is my small commuter car build. I picked up a 09 corolla coupe of months ago did some small mods. I started off my system with a eclipse 7200 headunit, mb quart qsd216 in the front, zapco iforce 6x9 in the rear, jl audio 300/4, n 500/1v2. With some fosgate p1s that i had from my previous car. Then I wanted something that was louder after askin jacob a million questions i got a saz-1500d and nightshade 15. I also bought a powermasters 2400, big 3, ran 0 ga to the amp, n kept 4ga for the mids amp . I got a box made from James from Tech12volts.com Thanks for his help, its a 3 cu ft box + port tuned to 35hz. I just wanted to thank Jacob and James for there great customer service and there help. Heres some pics of my car of the old stuff and new. IT POUNDS AND SOUNDS GOOD. this is some of the old stuff THE GOOD STUFF, the CAP is only a voltage reader n is only connected to the mids amp.

yea i just got my nightsshade and got the stock 3 layer spider, cooling option and the longer coil. To go with my SAZ1500d.

install it, and tell us how it sounds, i have preordered one too

yea i was going to get the bp option, i also have to redo my wiring to 0 ga, n buy a good battery, if i stay 2 ohm, i can leave the 4ga, n not get the bp option. how much of a difference will there be in sound?

i listen to some pretty much of everything mostly rap. Goals is to sound clean and loud, have nice accurate bass. For mids right now i have a jl 300/4 mb quart qsd216s in front n zapco 6x9 in rear.

Hey guys i have a couple of questions, i got a saz1500d, and i am going to be ordering a 15q, should i run the sub at 2 ohms (800watts rms) or 1 ohm (1500rms)? Right now i only have 4 ga running to the back, will that be okay if i run it at 1ohms or should i stick with 2 ohms, I am going to run the most likely sealed in a 2.5 cu ft box. i have a 09 toyota corolla, not that much trunk space, or will it sound better in a 3 cu ft box ported? If you guys have any other helpful tips please let me know. Thanks