Duran

Could I bridge two channels and wire them parallel for 2 ohms?

Not without custom order coils. Would be pretty expensive. Like how much? I just got a 100.4 and I want another one, use 2 channels for these 8's and the others for my rear deck.

Damn you ^ J/K LOL, a 100.2 is next on the list.

Money sent!

Is it possible to make 2 single 2 ohm?

Why's that? Wouldn't I only be able to get 1600w out of the amp @ 2ohms? Is the 3000 over kill for the sub? If so I would go with the 1500. lol no the btl can handle up to 5000W, a 3000D would be perfect for daily use So, remove HiXim coil? And back to my question wouldn't I only get 1600w if the sub is a 2ohms? Check the my post above buddy.

Why's that? Wouldn't I only be able to get 1600w out of the amp @ 2ohms? Is the 3000 over kill for the sub? If so I would go with the 1500. No, get the D2 ohm and wire it to 1 ohm. Stick with the SAZ 3000D

I buy these in 2/0 Gauge, solid brass: I solder it with a propane torch and it looks like this: Then wrap it in this loom:

Great score, did you run at all though?

Wise tactic.

$2.75 here

Uhhh, I'm pretty sure he's talking about this sub...

Its actually a toss up though, if you want to get louder with the same power get the BTL. Given the same amp, lets say a Sundown SAZ 1500D hooked up to a fully loaded BL, yes it will be loud, take the same amp and put it on a BTL, it will get even louder. But do you want to pay extra for a few tenths of a dB? Most people will say no, but I think its smarter to get the BTL and then that will leave room for improvement. good advice and yes the btl is fi's loudest sub but like he said 2 12 btl's. ull need some powerful amps to run their 2000w rms and some good electrical That's the beauty of the BTL though! You could have 1000 watts RMS between the both of them and clip the hell out of them and still be fine.

Its actually a toss up though, if you want to get louder with the same power get the BTL. Given the same amp, lets say a Sundown SAZ 1500D hooked up to a fully loaded BL, yes it will be loud, take the same amp and put it on a BTL, it will get even louder. But do you want to pay extra for a few tenths of a dB? Most people will say no, but I think its smarter to get the BTL and then that will leave room for improvement.

How so? He wants a sub that is loud that sounds decent. What's confusing about that. From what I hear on this forum the BL's do sound decent and get loud. Both the BL and BTL have a Daily and a SPL option. He wants something for a loud daily driver that'll sound decent. Daily doesn't mean it will sound good, it means that there is a bigger gap between the magnet and the voice coil, it is more forgiving than the SPL option which is a VERY small gap. You only use the SPL option for a one note burp, play music and you will be sorry.

It was something that his father brought home from work. He works for a major airline. (can't say which one) Is it possible to get some? I absolutely HATE using mat, or freaking kitty hair!

Damn, looks so clean!

SOLDER IT! Works better.

It is Saturday a know

It's the sensitivity that makes it "louder"

I'm really surprised there, with 2,500 watts you should be doing better than that though. dude are you kidding, thats pretty good considering its a single sub setup and with the seats up. now your score is a little shiity Not really there buddy, I only have 500 watts, he has 2,500. Don't be dumb. Of course its on the low side! It's freaking entry level 12's! Damn some people are retards!There is no point in arguing over stupid chit like that, its like the Special Olympics, who cares if you win or lose, you are still retarded!

What is the glass that you used? it looks amazing!

I'm really surprised there, with 2,500 watts you should be doing better than that though.