gacker

dallas fort worth area

Because I'd have to get a monstrous amp to pull the amount of wattage I want at 2ohms..

Dual 2. Which is why strapping 2 amps would probably be best for me I believe

2 12" BLs @2ohms ea.. been running them off an Atomic 3k mono. Amp is just about shot though, spent 250 getting it repaired already and still doesn't perform correctly. Been looking at getting 2 Sundown 1500s or 2 Sundown 1200s and strapping them.Will I see too much of a ddifference in performance with that little extra wattage? Or will the 1200s suffice just fine? Or does anyone have any other suggestions for an amp to run them on? Money isn't too much of a concern

Plays steady ranging from 13.4-13.9v amp goes into protect when it drops to about 12.9v And it's kind of a popping noise for lack of. Better terminology, like a short 2 second drum roll of bass.

Check your voltage at the amp when the system is is Playing. Also what ohms are you running it at? I'll go buy a MM and I will, seem to have missplaced mine. -___- And at 2ohms, only drawing about 2200 watts from the amp.

It's an Atomic 3000.1 2 FI BLs @2ohms 1200 XS power battery in the rear 2 runs of 0 gauge wiring stock alternator/front battery Has been playing fine the past week or so, but as of yesterday, any time the volume gets turned up around halfway, nothing ridiculously maxed out, the subs make a funny noise and the amp goes into protection mode. I've already checked that the ground is good, no loose wires or anything touching metal, the usual routine checks.. Not sure if it is getting starved for power or what's wrong at all. I'm not 100% audio savey but I know bits and pieces here and there. The amp is an older model that was damaged when I bought it, but I sent it back to Atomic and they fixed it for a flat rate. As I said, it played for about a week or so quite fine, then began doing this. Any help/suggestions would be appreciated.

North Richland Hills, in the Dallas-Ft Worth area

XS Power D1200 in the back, stock alternator though.

2000 @2 3200 @1 It sounds crisp and clear at 2ohms, nut near enough power for me though.

Daily.

They delivered yesterday, so unfortunately not. This wasn't the amp I had originally planned on getting. I could always just get another and strap them I suppose.

Because I was such a genius and goofed up by ordering them @ 2ohms ea

Would it be smart to run the BLs down to 0.5ohms for daily use if I upgraded all my electrical? The amp is an Atomic 3000.1d

Order 1997, arrives this Wednesday (19th) ! Very excited!