tosh

im looking to redo my set up. want to go with all sundown amps this time. will eventually go active or use the 3/4 chanels fo mid bass. after i buy my saz1500 & subs but until then can i use my 1/2 chns to run my comps passive and bridge 3/4 at 2 ohms on a small sub? or does it have to be at 4ohm? and what type of output can i get out of the bridged chns at each ohm load. i going to order the new heatsink model by the way.

so i can get 100wt x 2 for my comps and how does the amp do 360wt bridged 3-4?

have a set of dual 2ohm subs. that i will later switch out to a single set up. my question is how safe could run a saz1500 at .5 ohms on them until i switch over ? or should i just wire them to 2ohms and put up with less power. to be safe.

stock 105 alt ,deka under hood,big3

could you tell me what the volume and tunning is is on that awsome box

kinda a general question but what is a good sub to run off 400-500 wts rms. want decent sq. i will put it in sealed or ported which ever works best. budget no more than $250

i will look into the SI,..about the icon how would it do on such low wattage?

i was going to order some of those krystal rca's. are you guys saying they are crap? or just not as good as they should be for the price. if so who has good rca cable,

anybody have imfo or comments on db electrical's hi output alternator?

i have around 900wts at 2 ohms looking to do a single 15" ported box. listen to rap and classic rock. which would work best a Q or ssd wth copper vc.

would 900wts at 2ohm be ok to match up with a 15"icon in a fisher ported box

whats the link to check these out

3 12" icons in a sealed 4.5 cube sealed box 3000 watts anyone have feedback. an idea ive been thinkin it may be my new setup

i posted this in other section want some feedback from the ssa pros, want to do 3 12" icons with 4.5 cubes sealed ,running 3000wts any ideas? i have about 6.5 cubes total i can use maybe 4 12's or 3 15". anyone got ideas on this or other combos? want to try something diff. a clean hard hittin sealed set up

phnx gold rsd 6.5 comps and rsd coax in rear doors. got the doors deaden and will doo entire vehicle when i change. 150w x 4 amp

who is dave and where is the link to check it out

u mean i can get a 5-7kwt sundown amp for $1200

just a feeler as to what everone is running their 15's as far as box and power.im going run one with 1000w at 2ohm.i see the rec. box range between 3.5 and 4 for optimum 27 -33hz. i have the space ,would i get noticeable differance . how does 4cbs at 30hz sound any feedback is good.

is that slot or aero port. and if slot how many sq inches

can anyone tell me if they have actual output numbers for one of these amps at 4ohm and 2ohm

can anyone give me ideas on a box design for a rlp 18. its for a suv , sub up and port back. i have room for around 7cubes. want it tuned low. or if anyone has suggestions on how they are running their 18's. port area,freq,power or anything would help

s10 blazer. i have 6.5 door space tweeter space in dash.if i added another set of comps in the kick panel would i wreck my sq. just wondering being that one tweet in dash one down in kick. how about comps in kick panel and use the door for just a 6.5 mid

maybe not in terms of pure sq, more like will it sound ok and not run into some weird cancellation that would make listening suck

wanting to do 2 12" in a suv. will be amped wth around 1800wts. cant decide which one to go with . soundsplinter rlp's or fi q's. they will be used in a low tuned ported box. just want some feedback or comments on the two.