aleister2k

Have you given any thought to Powermaster? I have a 3100d running backup power for my saz-3000 and it works quite well.

awesome thank you! Was afraud I was going to have to exchange my head unit..

Ok, so I just got a new 3000d and a 100.4. My HU only had front/rear, no sub pre-amp output. Question is, if I wire the front/rear to the 100.4, if i Use the channel 1/2 output to the 3000d, will I lose my ability to use the hp/lp settings on 1 and 2 or if I do use the hp/lp will it still send a full signal through the 1/2 output? Sorry if I am not being very clear.. front / rear from head unit into 1/2 and 3/4 of the 100.4 1/2 output to 1 on 3000d will using filter controls on 100.4 impact frequency output on 1/2 output channels?

Hi all! I have a 2004 Dodge Ram Quad cab. These things are impossible for trying to put in subs without pulling out seats and all kinds of stuff (not interested in). Found a guy who makes a specific "molded" box that goes underneath the rear seats. I really want to go with the Fi Q 12", heard really good things about the Q's and I prefer 12's over 10's for the notes they hit. However, this box has a single chamber totalling 1.8ft^3 in a sealed setup for a 12". Will the .9 - displacement per sub be enough to adequately run? How much polyfil should I use? He also makes a 10" vented @ 36hz and 10" sealed. The airspace would be the same as the above box. Would it really sound that much better to go down to the 10" just for the extra airspace requirements the 12" has? Please direct me! Trying to get the best SQ while having the most SPL I can. These will be powered by a SAZ-3000d sundown. In case you are interested here is teh page with the different boxes: http://www.foxacoustics.com/gpage.html

What would happen if I ran 550w to each of the 12" until I could get the electrical upgraded for the saz-3000d? I have a dei 1100d runs 1100 @ 1 ohm, have not tested to see if over / underrated (do not even know how to do that).

already asked, since these are created from molds and are basically high resilience plastic, it cost him $8000 to have a new mold created so no changes are possible.

thanks for the info. I definitely plan on going for the BP option and 1 ohm. I was not looking at the .9 for 10" sealed, but .9 for the 10" vented....