extreme shock

Which one would you go with

True. Since Adire Audio is gone, everybody else said the way to go is FI Audio. So I decided to go for SSD's after reading some reviews, I know the Q's are a hella of a sub also but I hear the SSD's is pretty good bang for the buck. But I couldn't decide on the coil and would I really hear the difference in between the flatwind vs copper

I guess you really consider them to be SQ subs also. But the Shop I got them from a while ago said they could be use as some spl subs also depending on the install.

This system is more of good SQ I want it to hit hard but sound real good. In my other car I running SPL subs, I have 2 Brahma MKII's each powered by JBL BP1200.1.

Im getting two SSD's I would rather run them in 4 ohms just to run the amp a little cooler. Do you think that amp would be enough to power two of them?

I would like to know something. I just sold my Alpine Type-R 12's and I think I'm buy some FI SSD's but I need some help with the options. I'm going with dual 2 ohms, with the BP power, what I need help with is what coil to go with I was thinking just staying with the copper coil, but don't know if the flatwind would be better. I'm running the Alpine MRD-m1005.

sorry about that, it is 1.75 per sub. Would anybody know about what size and tune would sound the best in my car and should I take the 6x9's out of my rear deck or are they ok to leave in there. Im am trying to get the most spl's I can, that's what Im coming for Thanks

I have a 97 accord sedan, I running a alpine hu I have 3 JBl BP series amps. the 80.4 for my highs and Im running the BP 1200.1 per sub. As for Subs, I have the MKII 12's Brahma's (2) in a 1.75 cubic feet box I think tuned an 30hz. I don't think it hits hard enough I haven't had it tested yet. Im looking for some suggestions for a new setup to get a deeper and harder bang. Could someone help with some ideas, even if I have to use the whole trunk im fine with it

97 here and I have two 12's with subs and port both firing back

what size box and and what hz is best to have for those subs, I was thinking about trying 2.5 per sub.

Maybe somebody on here could help me with this question I have, I have two Brahma MkII 12's and they sound good I have a JBL BP1200.1 per sub, at 3.2 ohms in a 1.7cf boxes for sub. I want louder so I want to know should I go with a bigger box and leave them at a 3.2 ohm load or should I bridge the amp and leave the same box or bridge and go bigger box also. the amp is rated at 1200x1 at 2 ohms and 600x1 at 4 ohms, So I figured that at 3.2 oms I am running close to the 600 watts most of the time. Could really use some help, Thanks

A newbie saying what up. My name is woo. At the time Im running two Brahmas mark IV power by the JBL BP1200.1 per sub and the 80.4 for my highs. Im thinkin about changing up so I will be asking for some help. Thanks