ricksi30

Just thought I'd start a thread. Maybe post what you're going as this year? Have fun and be safe! Edit: Halloween*

Add a little fake blood and you will be scary haha.

You have us all beat!

500 Rms is plenty.

ya i seen that post. and it really pisses me off. i had my whole set-up jacked just like him (except mine was only like a $500 hit unlike his $1500 hit) it really sucks He got hit for a lot more than 1500.

This is true.

he said he will give me the sub for $50. iv never seen it and he cant send pics. i asked what series sub it was and he said he dont know because there is nothing that says what it is. lol stolen or he's literally a tard with a bunch of nice toys. Exactly. My money is on stolen if he doesn't even know what sub it is.

Haha it is NEVER ending.

At least you'll have a good excuse to do suspension now.

Me too! It's awkward to move and >100lbs. It should definitely help the XCON's beat up your Xb.

Really like them!

Nice pics! One of things that I miss about living in Jersey (Short drive to the city)

And 6Ft 200lb Garrett standing in the port.

Here are a few more pictures.

3,400,000watts may be pushing it Duran.

Agreed.

Good, two ohms is a much better option. Those box specs sound pretty good, you can even go a little bigger if you have the room. Just make sure to leave enough airspace for a nice big port.

Just wire them to 2 ohms and they'll see 1600-1700 a piece, which is plenty for daily.

Thanks for the info. Always good to have someones opinion who has had some first hand experience with the driver.

Welcome to the forum! I'd just like to point out that you can't run three dvc 2 or 4 ohm subs at exactly 2 ohms. Dual twos you can get a 1.33 load and dual fours you can get a 2.67 load.

I'll pm you right now.

Cool really hope it solves your problem. If not you can check it off of the list at the very least.

And the fact that you were switching amps also hints at it being that.

I can't say that I'm 100 percent sure but I do remember hearing about a similar problem with Kenwood. I could be making it up though haha. Just trying to help. Ground the rcas behind the hu and see if it goes away.

Same issue with some Kenwood units. Look up "pico fuse pioneer" and you'll find info on it.