psychomantis

I have lots of open space behind and under the rear seat, als i plan to put my sub amp there too.and passive for me im sure. i like to listen but im not an audiophile.

Ok I will give it a try. ill update wensday and let you guys know. What kind of amp do you suggest for the front? The deck has a lot of built in features.

So I read your post a little better now that my hands are free. Ok I will disconect the rears and give it ago. If that is the issue I need to amp the fronts due to not loud enough im sure. Also I was looking at an xcon. though I still need to build a center consol for the truck.

do you think THE is killing the sound? ill remove ant test/it worksat lower levels then dies after i turn it up. and i did the fronts amd deck.

So I have a Alpine ute52bt that is cutting out whwn I turn it up. I first thought it was a connection So it was checked. Tried to move the ground from factory to bear metal to battery and it still cuts out once I start to turn up the volume. do you guys have any other ideas? Sorry for the short post. My set up is the deck listed. A pair of i65c and a pair of infinitys in the rear. Nothing follows.

You've had no luck yet? If I was in Tennessee I'd grab them. Though I'm in nm and only want one.

Yeah I'm still looking around. No offense taken. I'm still looking around. I. Unsure still I haven't heard many systems yet so I don't have alot of basis. Though I lave lots of space. .

As it states in have a few questions about a new system. So far in have a set of i65c in the front doors and an alpine ute52bt I'm not sure where to go from there. It want to run passive due to i don't have the ear for tuning. Also if am looking at an xcon. I'm not sure about amps to power what is have now. Or if it should look at other things.. any info would help or suggestions.

That stuff is way cheaper than the knukoncepts that I was looking at.

I was just curious honestly. So where should I look for wire?

My current system on the truck already looks to be at 1/0 though stock.. ill take another pic and try to show the size of the wiring though I know the casing isnt what you wana see.

I am looking at an xcon and a saz1500, and maybe a few light down the road..

My question is with the photos shown would it be worth the big 3 update. The wires I have now are quite large both negatives go to the engine block and there is a little one off of the passneger side that is petite that goes to the truck It is the only one I see so far that actually goes to the body the others deal with the engine.

Cool thanks I will just Order my xcon then :3

Imma come back to this after I get back.. hopefully it is still here