bulldogfreddy

Just made my 3 month mark, March 18 is when I placed my order. Can't wait to see how they sound in this box.

Don't know if I should put less angle on the triangle

Nevermind, I think this will be a better fit for me. (2/4 Kit For 99-06 GM Truck).

Thanks for the link, I was looking the (Belltech 2-3/4 00-06 Tahoe Yukon Escalade ETC lowering kit). I don't how bad the ride will be with 2" drop in the front.

Got fine thread kreg screws instead of coarse thread. I have exchange them so I can finish the back, top, corner bracing and parallel dowels. I see that a lot people orders being shipped out and hope I am in at least the next batch.

Looking good Lee, is the ride any different being lowered? I am also thinking about dipping my rims since they are old and seen salt water of Hawaii.

Thanks.

One baffle done

Going brace with 2" dowels and still have to cut and place corner braces. Still debating on running a full port divider down middle or a partial. Made the box a little bigger than design. 50" X 20" X 38".Looks good man! I think you'll be happy with the birch decision. I probably would try to avoid putting a brace in the port as it'll increase turbulence in there. Maybe just double up the side walls of the port and round over the ends. I was worry about the rear of the port. Because they will firing into each other except in the center at rear where I will add a deflection (triangle). Double up on port walls, that will be with birch ply. Lol. I used a total of three sheets of BB for the box already.

Going brace with 2" dowels and still have to cut and place corner braces. Still debating on running a full port divider down middle or a partial. Made the box a little bigger than design. 50" X 20" X 38".

Well, I finally went out and brought the the Baltic Birch and it is about the same weight as mdf. It did cut light butter. Still have to go over the cuts with my flush trim bit and cut the holes out for the subs.

There a big difference from baltic birch ply and shop birch (11 or 13) for this kind of application.

I seen one lumber yard have prefinished birch on both sides.