TRZ

Let me know when the 10's will be ready

10" is very nice

76

Try a Audison bit one now that thing is by far superior it has some really unbelievable features.

They are pretty good in med sized ported enclosures with moderate power , we installed a pair in a older cutlass with a 4kw mojo and it hammers pretty good . There were two DD 9515 in the car prior to the z"s and the customer is much happier now . He has been beating on them now for about 2-3 months. They are very musical and have good control even when played loud. I would say that if someone bought a pair and threw them on a 2000saz or 1500 saz they would be pretty impressed to say the least especially in a well constructed enclosure ,and it would not kill the budget ether

I love the Zs.. x2

Should be larger than normal crowd. Also Dave Edwards (Hybrid Tech) will be judging the sq portion of the event.

Tarheels Auto Sound Challenge # 3 Sunday May 17th all classes spl/sq/dbspl registration starts at 9:00 AM and closes at 1:00PM. This is a MECA 2x point event . We would also like to welcome NSCSPL to the event as they will also be hosting a show as well. That's right we will be holding TWO shows at once. Hope to see you there.

Tarheels Auto Sound Challenge # 3 Sunday May 17th all classes spl/sq/dbspl registration starts at 9:00 AM and closes at 1:00PM. This is a MECA 2x point event . We would also like to welcome NSCSPL to the event as they will also be hosting a show as well. That's right we will be holding TWO shows at once. Hope to see you there.

Tarheels Auto Sound challenge # 2 This is a 2X MECA points event. Reg opens at 9:00 am and closes 1:00pm SPL ,SQ , Drive by and rta freq. The location is Tremorz Auto Sound located at 1124 N Barkley rd. Statesville NC. (704) 883-8428 http://www.mecacaraudio.com/flyers/4-19-09NCv2.pdf

Hows the xcons

Hope to see you there, should be good show.

If you have a way to get a term lab or even an ac ,try a sweep from 20 to 100hz and see were your peak freq is.some shops only charge around $20.00 to use term for 20-30 min (money well spent) this will allow you to play with you placement and filters on your amps to get the most out of your system as it is. Also if you have a dmm and an ac clamp. Play your peak freq and Clamp the positive wire(s) going from your amp to your box and set the clamp on ac (A) then set your dmm to ac (V) and put the red prob on the + of the amp and the black to the neg of the amp . make note of the numbers .Take the numbers you came up with and use this formula: volts divided by amps=rise (ohms).That will be the rise the amp is seeing, it will give you a way of figuring out what problems you have or at least a starting point. Also make sure the subs are wired correctly and test that they are wired correctly (compression and refraction)and make sure you are not overlapping your filters on the amp as well.