Impact9

This has been going for a bit and I was wondering if there are any left?

I'm looking for plans or a possible build for my Stereo Integrity BM10. I have a LMI welding seat lift in my truck right now so I may have sufficient space under the seat. To fit it would need to have a wedge shape with dimensions of 30" wide, 17" deep, 10" tall on the front, and slanted down to 5" tall at the back. I'm over in Wichita so coming to pick up wouldn't be too far for me. I tried requesting the quote at the website but it says product not found. Here's the specs for the sub. [T/S Parameters: Re (coils in series) Fs 27.1 Le 3.38 Qms 3.08 Qes 0.31 Qts 0.29 Cms Mms 101 Vas 52.5 Sd BL 21.7 SPL 87.4 Displacement .1 ft^3 Recommended enclosures: Ported 1.5 ft^3 tuned to 36 Hz

Thanks! I can email dylan since the design is all I need.

Damnit wasn't there a picture of the new proto mags on this forum yesterday? I could of sworn I seen it when i was on the site at work. now i can't seem to find the thread it was in anywhere or was I was day dreaming? Do we have any rough estimates on the mounting depth the new mag might be?

Mother of God man what is the mounting depth of this monster? I guess there's no way in hell I'd be able to get that to fit under my seats in my Supercrew F150.

I'm trying to find some good photos of recent productions of the XT4000D. Reason being is that I think this guy sold me a counterfeit amp. I'm going to post pictures of this suspect in a few minutes. I was just here hoping to find something that might help me prove this fake. I did at least buy it on my credit card so I'm safe there.

Uhm it's a mono block there is no "bridge mode" it is wired parallel internally..... EDIT : Damn didn't read 90accordman posts i went straight to posting what i noticed right off the bat Thanks guys saves me and the seller some headaches. Far as bridged goes, only reliable image source I have is usamps.com. Their pics show bridged on the terminals, hence my confusion. Plus the lack of the correct manual for the amp didn't help me as a first time mono block buyer.

Ok I just found a post by jrlutor and if my research is correct, is the VP for US Amps http://www.soundsolutionsaudio.com/forum/i...st&p=233403 Did US AMPS remove the bridged graphics and case bevel? I really hate this crap, no online manuals and you have to dig through this board looking for clues.

Notice in this image the bevel on the heat sink is very sharp. On my other Exterminators this bevel is smooth, more rounded over. The camera seems to be taking some of the edge off but it is quite, for the lack of a better word, sharp. Sorry for the inverted image, my amps are mounted vertially. This is where the real problem lies. The speaker label is missing the bridged mode graphics. I tried running the amp bridged with a 4 ohm load and it just won't work. I run it off 1 channel with the 4 ohm load and it will work. If anyone has anything they can share please do.