Quentin Jarrell

The 12" Klippel results can be found above. They will change slightly due to cooling that was added and a bit longer coil to get xmax to 32mm. And I am using a black chrome finish on the motors.

I wonder if he still has that amp?

I am firm on 350 shipped

Brand new N3 12inch Dual 2 ohm with cooling option. condition 9.75 out of 10 (scuff on bottom of back plate) never installed in an enclosure (see mounting hole close up) only clamped onto an tested by Klippel analyzer $675 shipped in the lower 48. I paid 799.94 with shipping

350 shipped for the motor and basket. If you want it send payment to PayPal address [email protected]. Spider and edge residue still on the basket and will have to be cleaned before reconed

Why would you want a 35 ah battery.

I can't believe you just said that. An underrated fuse will still blow. But you can use one smaller that is just big enough to last long enough to get a score. I was being sarcastic. I would hope any judge would be able to see the difference.

That doesn't matter. Your alternator could be capable of producing 1 million watts and you could have a battery bank of a thousand batteries but if you don't have anything pulling current then no current will flow through the wiring.

Bags are 50 kilo sacks baled in bundles.

Well...flight was filmed in New Orleans.

http://i268.photobucket.com/albums/jj3/audibelcustoms/image-2.jpg

LOL no, it's empty sacks in bales. They will be used to bag up 14,000 metric tons of milled rice.

TTT

If I was moving that much. I sure the hell wouldn't be here. What's 50 tons going for on the street now a days?

Or you could just drill out the pop rivets and put a 80 amp casing on a 250 amp fuse.

Fuses pop or melt due to the heat generated by the current passi g thru them. A lower rated fuse will work for a burp bc the fuse doesn't have sufficient time to heat up.

After being in the business for 12 years Focal is the only brand I recommend. I personally use the Polyglass series. Your not gonna find another car audio brand that puts as much design effort in their products. Focal's xovers are built well enough you can normally run them full range. Every high end vehicle install I've done was with Solid amps ran full range to Focal components.

http://www.amazon.com/gp/aw/d/B001P80920/ref=mp_s_a_1?pi=SL75&qid=1352923283&sr=8-1

A crossover is nothing more than a voltage limiter. So you'd use the AC voltage setting to find where the crossover is at. You shouldn't use the markings on amps for crossover settings anyway. Pots can be off upwards of 20%. Set amp with sub unhooked, the sub's capatance will alter voltage seen on the meter.

I'd like to see Audio Precision test the DD-1. Just to see if the algorithm it uses works properly.

Around 2003 Mark Fukuda (with RTTI) at the time had a display board set up with a cheap radio shack head unit, a highend head unit, and a Rockford headunit hooked to a RF amp. All units were gain matched at low volume with an Audio Precision meter and the board had a switch to change sources. You couldn't tell the difference in quality if it was on the high dollar head unit or the cheap radio shack one.

Glad it came out good for you.

I didn't think 05's were xbl

Nope still got it but I pulled the cone from it. I wasn't thrilled about the coil that was on it.

Best for what?