Quentin Jarrell

Hey thanks never even seen that. I will have to how to make this work or something different. What do u suggestThere are tabs on the back of the seat that slide into the rear wall of the cab. Something akind to a ironing board hanging over the top of a door. For safety reasons I wouldn't go any higher than the stock floor bolt will allow. ~1 inch. I have easily done over 200 boxes under the back seats of trucks. Depending on the year under the bottom of the seat will be hollow. Therefore a downfired box can have a hump by the speaker magnet to allow for a deeper sub. You have a lot of options. Your budget will determine which route to go. Personally if it was my vehicle I would do a single Jl W6 12 or SSA ICON 12 downfired. The enclosure would go all the way across the back seat with the sub on the driver side and the port on the passenger side with the port exiting towards the passenger door. However my build skills are fairly above average.

Or you could use all thread and hang em off the rear deck.

Told u

No that's the price of owning a FORD

You know upholstery suppliers make steering wheel kits with the sewing holes pre punched.

What year is this? 2" ain't gonna work. The tabs on the back of the seat won't have anything to hold on to.

What's the going rate for a 966

The M3 is a dog compared to the 911. Not even a comparison.

Well the viper is more my preference. I was trying to be non biased.looked at those too, but i think the Porsche fits me better. awd, turbo, small and handles like its on rails.. With a driver that actually knows how to drive the gen three viper tear the the 966 a new one on the track. Although the GT3 will give the viper a workout if its not the ACR model. But that is what the car was designed for. For the track. They are two completely different driving experiences. If I was going to be driving through town in traffic going to work I would want the 911. If I was cruising on the weekend with a little track time now and then I'd take the viper hands down. Hopefully ill be back in a viper by Xmas this year.

Well the viper is more my preference. I was trying to be non biased.

It's a 400 horse AWD car with traction control. Throw a set of PS2's on it and there will be no problems hooking up. They run good on the track. Fairly comfortable for daily driving but have a small cockpit.

Feelings as compared to ? Looks performance?

That's not gonna do much good if the resin seperates from the steel. Stick a pry tool between the roof and fiberglass. If you can make it peel off its not gonna last.

my roof is soo thin the weld will just burn right through... and i know kyle i took it out tonight just gotta see if putting on the pulley is the only problem... not sure if it messed up anything when the pulley came off.. You need to find a better Welder. My Miller is rated for 3/4" and I can weld a coke can with proper sized wire.

http://www.amazon.com/gp/aw/d/B0035VX6UW/ref=mw_dp_mpd?pd=1&qid=1363355138&sr=8-2

I do t know if those amps are strapable. However they would be seriesed not bridged. In order to do this without tearing the amps up you would have to series the subs as the amps would not be able to handle a .5 ohm load. So you would be sending the same amount of power. Normally amp ratings are less strapped than single.

Corrosion build up on terminals are from chemical gasses corroding the metal.

Rise is gonna be around 15-25 ohms.

Mark said he had to upgrade the mobile version.

If you are driving and heading farther south Savannah, Ga is worth a stop. It has plenty history as well.

Did you just fiberglass the mat to the steel? When it turns summertime that laminate will seperate from the steel from expansion. I've already learned the hard way. Just make sure when you finish the install that you will have access to it so you will have the ability to reattach it with liquid nails or epoxy.

Mamacita's taqueria on biltmore ave is probably the best Mexican place in Ashville.

Asheville, NC ? We normally stay at the builtmore every April. We have a couple caning in Gatlinburg, TN. We stay a few days in gatlinburg hiking, taking pics, ect. Then take a ride to Ashville stay at the builtmore for a few nights. The Vanderbilts have an awsome garden in the spring. Cabins not caning

You said you ate beef tounge. Was it pickled?

Yea Tripe isn't cheap.