shizzzon

Well, here u go man, u dont have to be jealous anymore- http://www.ticketmaster.com/event/1E00449ABC645D9F?artistid=736426&majorcatid=10001&minorcatid=1 NOV.27th, they will be there in Arizona

The next following videos.. do NOT skip through them, you will destroy the playback of them and cause them to skip.. you must watch the video from the start.. you won't be disappointed... Remember.. all done via projectors only... http://s303.photobucket.com/albums/nn147/shizzzon/Concertz/?action=view&current=VIDEO0007.mp4 Next vid- http://s303.photobucket.com/albums/nn147/shizzzon/Concertz/?action=view&current=VIDEO0008.mp4 and the last one i have- http://s303.photobucket.com/albums/nn147/shizzzon/Concertz/?action=view&current=VIDEO0010.mp4

Here is a sample of the size of the wall... the wall is currently being built as the concert goes on.... then completely tore down.. And no i do not have a video fo that.. it was insane too... http://s303.photobucket.com/albums/nn147/shizzzon/Concertz/?action=view&current=VIDEO0006.mp4

Even better, hehe, he can walk there from KY now, lol.

then get off your ass and go! I'm sure you can make it to Texas by this weekend if u leave now, lmao.

Wow, the competing near you must be like taking candy from a baby Trial and error is only for fine tuning IMO, physics will dictate the rest. I would never arbitrarily build a box with an ultra long port and trim it. I'm serious, lol. It depends on what type of install one is doing but for his, that's how EVERYBODY does it, not just around here. I'll break it down into two classes- trunk or cargo\ wall. If building a typical box, we, competitors, build a port that can be cut and cut and cut until one reaches their maximum output potential.. For a wall, it's the complete opposite. One would build a bare wall with no port length and if tuning is too high, a competitor will add another internal layer to the baffle... and so on and so on... that will decrease volume but add port length too( sounds like you are getting no where but it does help...) If a competitor chooses not to do that, 2x4s added to the port length works too then just glass over them for a smooth finish... For a bandpass design, once it's built, competitors actually build a no port length to the outer chamber.. To tune it, they simply just decrease the forward-most chamber's volume by adding a layer of wood to it again and again until it peaks the way they want it. I know u used to compete but, hehe, if u have some insight.. as to how this is completely wrong, then you would be bringing on a whole new meaning of tuning a box for competition if u know what i mean.. You'd stop everybody in their tracks... It's the norm everywhere i've ever seen and been around and i've been to many shows.

It's all in the install and vehicle acoustics and how the car is modded to achieve even crazier scores... the A-team has been able to do a 154.x with less than 40w of power. This is an extreme vehicle.. major vehicle mods... I wouldnt worry about how it's possible... it's just proof that it's in the install so nobody should expect near 150s in every vehicle out there.. that's why there is competitions. If it were always that easy... then competitions would be a thing of the past.

you could do like us competitors do.. Trial and error your port tuning. Although, since you are aiming for daily, which is a lot easier, just build you the longest port u can get in there and see how it sounds. Start cutting a little off at a time if you think it's tuned too low until you get it how you want it.

Cthedinger, Software has now been tested and confirmed just a few minutes ago! We got it working! You are going to like it I hope! The software will now display LIVE digital frequency readout, Realtime PEAKing SPL, Realtime averaging SPL all at same time during your musical averages! I will be sending you an email for the new updated software. We met your deadline for your show just in time! Hope everything goes well at the show!

Did Slim2fattycake pm you about the meter needing to be updated when it's available? Typical Peak AVG output is around 5db above normal until it is fixed in case he didn't tell you. The fix will start commencing tomorrow.

do this- Take ALL 4 subs and individually wire each one in series to 2 ohm. So now, you will have 4 single coils at 2ohm.. 1 coil per sub. take 1 pair of subs (2 coils) and wire them in series to achieve a 4 ohm load. do this to the other pair(2 coils) of subs as well for a 4 ohm load. now you are left with 2 coils left, each at 4ohm... Now, just take that and parallel them together for a 2ohm load. WALA.

i'd like to see this..... without removing the AC compressor...

Bird Bird bird.. Bird is da word... B-B-B-B-B-B-B-Bird Bird Bird! The Bird is the Word!

sounds like it has been bottomed out for it to sound like it. SSDs are real particular about sticking to their suggested box sizes and to the power received.

For daily, I'd be aimin at enlarging internal volume and decreasing port area... Daily setups want the larger boxes because of the typical tuning frequency and the type of music being played. Because it takes a lot to hear a shift in loudness, maximum possible port area isn't a primary goal compared to proper internal volume.

remove the last letter of the last name in the thread title and it will be right.

looks like somebody is using a spycam.. naughty you...

r u sayin the only thing wrong with the sub is the dustcap? If it's just got a hole in it... cut it out(without cutting into the cone or former) and just buy u a new dust cap.. that's like a whole $8.

hadnt planned on it.. was planning on welding steel between layers of wood all the way around to prevent the walls from flexing inwards during pressure..

yep.. there have been some hiccups with gettin this stuff as it's been sellin fast but i can talk to the guy when u get here if u like and see where we stand on inventory.

none now.. next year.. it will be Modified but i'll be sneaky about it

i can call my man and see if he has any extra if u need them now? if not, let me know at LEAST 2-3 weeks in advance so i can fill your request.

i used to be into this.. U may be like me or you may not but coming from a person who builds pcs.... i still didn't want a carpc in my ride... I like to do things right and by right, i mean the best PSU for the pc, the best hard drive bay to prevent death, the best pure line in with no analog volume adjustments(like what u are looking for).. the best of everything.. because, it needs it. After factoring in over $1g easy.. and i was still counting up... i decided to stop... I was adding a LOT more than just a typical pc though too.. i was gonna set it up for video surveillance, etc... mp3car is a great overwhelming place to go but i would search in OTHER places before i go straight over there.. You will have a brain meltdown of information if you are new to carpc.. Due basic research on things to look for and expect then when you have a broad grasp of it.. then go to mp3car and find your detailed answers... Otherwise, you 'll keep digging yourself further and further into more and more complex knowledge that you'll be wantin to find out how the computer can control your house..lol. Ie- carpcs can monitor OBD-II diagnostics... as an example of things u need not know at this time... i could go on and on.

honestly, if i thought the ipod was effecting it.. it would be the higher notes, not the lower ones.