boy.kroy
Members-
Content Count
39 -
Joined
-
Last visited
Content Type
Profiles
Forums
Gallery
Everything posted by boy.kroy
-
Yes both coils connected in parrallel
-
The enclosure that i modeled was sealed 2.6 cubic feet with a qtc of 0.94375, fb-44.70, f3-36.
-
I apologize for using the capitals and not thoroughly reading the rules, or not giving enough info on my system or car. The equipment I currently have is 1 zed audio deuce, 1 (original) oz audio matrix elite 180cs not the new ones, 1 phoenix gold titanium elite 12d everything is still in the box never installed. I am planning on putting the oz comps in the rear, and running the front active (2 way or maybe 3 way) I want to keep my deuce, but i am considering selling my pg ti12d elite because i dont like the parameters that i got for it from my dayton audio wt2 which are: fs-36 qts-0.77 qes-0.87 vas-39L re-1.6 Le-1(0.997) Xmax([coil length-gap height]/2)-25.4mm(Car Audio & Electronics mag) Bl-somewhere around 11 tm(different readings from wt2) 1998 Honda Civic EX Coupe(back seats fold down) I guess my question is, should i sell the pg ti12d elite and get something else and if so what? I listen to rap, hip-hop, r&b, techno, jungle&bass(aphrodite), some alternative and classic rock, no jazz, no classical. I want it to sound deep, clear and loud inside the car(in order of importance) but i dont care how it sounds outside. If i should keep the pg ti12d elite what enclosure, installation? From my research i have found different parameters than what was measured and different opinions. I read that it loves low frequencies and i would need a strong midbass crossed over low but i have a calibrated wt2 and i get a fs of atleast 36 which i thought was high. Also I just purchased a 2006 toyota tacoma Access cab or extended cab, which one would be better for the install(tacoma or civic)? I am not expecting anyone to bash someone elses products or push there own product, i am simply asking what would u do?
-
I am going to read the rules before posting in here again.
-
Alpine PXA-H701 vs. Audio Control DQXS
boy.kroy posted a topic in Amplifiers / Head Units / Processors / Electrical
Alpine PXA-H701 w/RUX-C701 vs. AudioControl DQXS w/DDC -
How much power would I get if I Bridged a SAX-100.4 @ 8ohms? Does the SAX-100.4 have Sanken Bi-Polar output devices?
-
That is a first and very interesting post. Odd...I always thought the Q's were a little lacking in the "looks" department. The sub is not visually impressive in any way. In fact, I believe that was my one of the tow initial criticisms of the Q in my first review. As far as sound goes, the Q will blow most people away. Most people care to much about how the product looks compared to how it performs, which is why most of the products on the market today are mass produced beautiful looking garbage. I dont buy a sub to look at it, especiallly since i drive a sedan and what ever sub i have at the time is facing the rear in my trunk, no one drives around with there trunks open and there radio muted saying look at my pretty sub. Girls dont get in my car and say, my god that speaker sure does look nice. More like, "your bass is making me moist, do u want 2 go some where and park".
-
It was also double the price of the Q
-
I had the same problem with the surrounds on the first Gen. AA Arsenal 12's, with only 600 watts going to each one. The surrounds only lasted three months, Must be the foam! Wasnt using any bass boost and only had gains turned up 1/4 of the way. I loved how they sounded and how loud they were for the price, but both surrounds seperated from cone 3/4 of the way around.
-
I have a Dual 3-ohm Subwoofer, which i plan on wiring in parallel for a 1.5 ohm load (actually measures 1.55 on digital multimeter). Could I use Two SAE-1000D Strapped with this load? One Saz-1500d would not be enough and 3000w would be to much.
-
Well Phoenix Gold lists them as dual 4-ohm, but when i hook it up to a DMM in parallel it reads anywhere from 1.55 to 1.6 ohms, and when i use my Dayton Audio WT2 The RE reads 1.55 to 1.6 ohms, and I have a test report on it from CA&E (Car Audio & Electronics) magazine and they say its listed as dual 4-ohm but is actually Dual 3-ohm.
-
Phoenix Gold Titanium Elite Ti12d Elite RE: 1.59OHMS IN PARALLEL
-
Car: Chevy Blazer Extreme (2-door) Music: Three 6 Mafia, Little John, Crime Mob, etc. 2000w-3000w Total 2-12Q Ported or 3-10SSD Sealed?