michael

I want to get them reconed because the do sound good and hit hard. Plus I have a 1989 Bronco on 53 inch V-treads(6000$), 5 ton rears(3000$), and one sick 460 worked to a 488(11000$) with 600hp+ 250 shot of NOS!!!! I dont want to spend any more money on the bronco so thats why i wanted a recone. But i guess i wil have to get new subs. I see 2 15'' Q's going in there very soon. I have to many toys so the wife is bitchin about everything i buy. A list of my toys- 1989 bronco, 2003 Excursion, 2003 mach 1, 2002 raptor 660 worked to a 770, 2007 raptor 700, 2005 Hayabusa soon to have a turbo, and i want to get a new SRT8 Charger and sell the Mach 1. I waste MONEY and lots of it!!!!!!!!!!!!!!!!

Jl told me that they dont recone subs that old. Can someone tell what to do with them other then putting them in the trash. I know i can recone them i just need to find a recone kit.... any help

Thanks...

why not? they don't have 2.5 inch coils Do you know where i can get a recone without going to JL for the recone?

yes the whole strip mall and everything in it. The guy Dru who is airbrushing my things is cutting a check for my subs and box like today. I can control the gain so i wont kill the Havocs. Think the Havocs are a better sub or should i stay with the Q's or BL's? Want it loud and low with crazy bass!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

why not?

I took my box and 2-18'' Q's to get airbrushed. My box airbrushed to look like the cube from the movie Hellraiser and to have all my favorite horror movie people airbrushed on the whole cone. The shop next to it caught fire and burned up all the stores in the little strip mall. So I would like to know if I should get the new Havocs or stay with the Q's? The Q's hit hard and loud but I think the Havocs would hit harder and louder but I need them in dual 4 ohms. The Q's are dual 1 ohm. I need to run a 1 ohm load to my amp for full power. I have the MTX TE4001d. 3900 watts at 1 ohm, 2451 at 2 ohms, and 1323 4 ohms. Box size 7 cubes each after port tuned to 30hz. So would the Havocs do more then the Q's? And can I get the Havocs with 4 ohm coils? And can I use the same box design with the Havocs? (7 cubes 30hz) And I like the 30mm of xmax that the Havocs have. And the BL would be good for me to but site said that it only has 21mm xmax. I want excursion. Can I get alonger coil? More air moving = tickets...

well anyone?

Can I get a recone for 2 jl 12 w6's? My boy just smoked them and gave them to me. The only specs that I could find was, 300 watts rms, 2.5 inch coil, 11.1 xmax, and they are dual 6 ohm coils. And the dust cap comes with the recone? And what would be the new spes with the recone?

What sounds better? To fire them towards the rear? Or the port and sub on the same plane?

I have a excursion w/2 -18 Q's and want to know if i can tune them to 30hz instead of 28hz? and should i have the port and subs firing to the rear or facing up? all my boxes always had the port and sub on the same side.I would face them to the rear. I would face my box up and the bass cuts in half. Will this do same if i face the subs up and the port to the rear? I want to get the most that i can get out of subs and box. Any input....

I have a excursion w/2 -18 Q's and want to know if i can tune them to 30hz instead of 28hz? and should i have the port and subs firing to the rear or facing up? all my boxes always had the port and sub on the same side.I would face them to the rear. I would face my box up and the bass cuts in half. Will this do same if i face the subs up and the port to the rear? I want to get the most that i can get out of subs and box. Any input....

the 2 ohm coils have more bl then the 1 ohms coils. so would that mean that the 2 ohm subs would hit harder??

Can I get 4 ohm coils in the Q line? And would the 4 ohm sub have more bl?

Out of the Havoc 18'', Q 18'' w/bp, and a 18'' Bl loaded with 1500 watts which one will - 1.Hit the hardest 2.Move lots of air 3. sound the best at high volumes 4.Hit loud and low 5.and smoke the new orion HCCA 15. So which one will do?