james0223

ive been into car audio for three years mostly kicker but i decided to upgrade i have a rd1750.1 and a sundown nightshade v1 d1 15 i am new to hi end car audio so can someone tell me what voltage my output should be to have my gain set correctly at 2 ohms which is 840 watts and at point five which is 2225 watts please would appreciate the help dont wanna clip my new set up

i decided to use a 3.5 cubic foot sub up ports back (2 6 inch aeroports) tuned to 32 hrz box for my nightshade do u think that would sound good in a 97 chevy blazer thanks for the advice on tuning the gain im going to do that in the morning

hey thanks for the help i decided to go with a box design of 32 hrz sub up ports back 2 6 inch aero ports do u think that would suit my nightshade well in the back of an 97 chevy blazer just thought i would ask

new conceptz 0 gauge throughout big three 300 amp ho alt kinetik 3400 up front and 1800 in back my amp has the same board yours does

right now i have it ran at two ohms at 840 watts but i have the electrical to run the amp at .5 and the rms at .5 is 2225

ok figured out the electrical problem it was simple i really dont wanna change my cone because it modified by jacob at sundown and was quite expensive a normal recone for my sub is 110 dollars mine cost 265 so recone isnt an option i ran it at .5 ohms today for about three hours straight and it barely got warm switched battery to kinetik hc 2400 up front and hc 1800 in back

i have a nightshade v1 15 and a rd1750.1 amp right now i have my nightshade wired at two ohms but i got the rd because i was told it was .5 stable i have 0 guage throughout big three and 200 amp ho alt will that be good enough electric to safely run this amp at .5

if i out a stinger spv 35 as secondary battery then would it be enough to run at point 5

stock for now but car stays steady at 16 volts

i have a nightshade v1 15 dual 1 and a rd1750.1 that i will be running at .75 ohms i want deep clean low bass while listening to rap and rock please help me with box design specs