sundownz

Rated current draw is 350 amps. Derrick will be working on some 12v testing soon.

Little more testing... dropped it down to 40 Hz which is ~1.3 after rise : 11,470 watts 5735 per amp

Regular cost is $1549 MSRP / $1099 MAP.

Another 4 weeks or so remain to pre-order!

Sale still going on!

Yes, the subsonic was designed to be able to high pass the midrange to create a band-pass filter. I use mine in the Jeep this way

We had 100 pcs - they all sold within the first day of getting the amps in (yesterday).

You would need to send in your amp during the pre-order to qualify for pre-order pricing - so I'd say you will want to wait until towards the end.

Just called around to confirm some pending orders - looks like we are all sold out of this run.

Yah - I have yours on the list.

There are less than 10 still available... FYI. I may have to do another pre-order for the next run!

They are 3 lbs more than the 3000D.

Trucking company called me this morning - they expect to deliver it today. I have had them tell me this before and fail to do so... but lets hope for the best Shipping will START this week - we have so many pre-ordered they probably won't all ship by Friday. DO NOT PM OR E-MAIL ME ASKING IF YOURS IS SHIPPED - they will be shipped in the order they were pre-ordered and they will go out ASAP. Automatic tracking sent by UPS Quantum View - if you don't see it by some time next week check your bulk / spam folders.

Pricing will be the same as the SAZ-3000D. MSRP - 1549 MAP - 1099

They are on a truck on their way to me. That should mean tomorrow or Friday. We have ALOT of pre-orders so it'll take a few business days to get them all shipped.

ONE LEFT.

No problem

I will post as soon as I have anything new.

They have been doing alot more x-ray work since the economy went down hill.

Found out that they got held up to be hit with the x-ray twice - fun stuff. It MAY arrive by the end of the week, maybe.

E-Mail. [email protected]

So far the 1500s aren't much liking the 0.25 load. I can roll it and get a score but not high enough to do a GOOD score. So I may just need to wait for 3500s and use the 0.5 DCR load for now and then build some other subs later once I get it all dialed it for the 0.375 DCR load again.

Woops - I made a mistake earlier... must have looked at the wrong data for the subs I was using before. They are 3.0 DCR and not 3.5 DCR as I was assuming before. With those D4 coils all in parallel I had 0.375 DCR per amp, which is more like a 0.5 ohm nominal load. With the D1 Nightshades I built I have an actual 0.50 DCR load per amp, which is more like 0.70 ohms nominal. Even still... it is doing 154.3 dB with a DCR much higher. I may have to wire the amps down lower and try it that way with these coils. Or use a different amp configuration like four 1500Ds wired down to 0.25 DCR each to get a better comparison.

I disabled my PMs. If you sent me a PM and did not get a reply please e-mail me.