voce

Gain is set pretty high, 70%. Bassboost is at 0. Tried to guess where 28hz was for LPF. Subsonic filter I can't recall. Want to say 1/3 of the way up, 10hz - 300hz is what i think the dial has control over. Is SSF too high? EQ on the deck is flat at the moment but the sub level is set to 7/15 (Alpine cda117)

Ah ok, I was thrown off by the two sets of terminals. So just connect + to + then send it to amp, same for negative. Got it. I wont be able to do all this until after work tomorrow, is there any possible damage from how i have it wired now or is it just getting less power? *edit* Thanks for the diagram stefanhinote

Hey, I'm wiring a 2ohm DVC Fi Q to a Sundown Audio SAX-1200D. Being a monoblock amp I don't know how to wire this properly. I've checked quiet a few of the websites with wiring diagrams but none of them are showing how to hook up to an amp with double connections ++ -- All they show are mono or multiple channel configurations. Currently the sub is wired following this diagram http://a248.e.akamai.net/pix.crutchfield.com/ca/learningcenter/car/subwoofer_wiring/1DVC_2-ohm_mono.jpg Looking directly at the side of the amp with speaker connections, brackets = [wire] [+] + [-] - I think with the way I have it wired that it's running @ 4ohm. The goal is 1ohm. Also, I need to give a big thank you to everyone who helped me pick out equipment and wire. I'll post some pics once everything is correctly hooked up, cleaned up, and carpeted.

Good call on using it for mid /highs amp, I'll just run with a 4ga kit for now. Thanks cheese @ Nick_W No I haven't done the big 3 yet. I plan on looking at a new vehicle after the holidays so it really depends on how this car handles the draw. If I can get by without doing it until I get a new vehicle I'd rather just do that. Not to mention the stock battery is in the trunk so I'd have to run a ton of 0ga wiring to the front. Stock alt is 105amp so I'm hoping for the best. Thanks to everyone for the help Voce

I was wanting to go with 0ga wiring but I noticed the amp (SAX-1200D) has 4ga power connectors. Is there a way around that like using a reducer / adapter or something?

*Update* I put in the order for a single Q12 today Looking at 4ga wiring kits for the setup.. what do you guys think of KnuKonceptz or Stinger brands of wire? Side note, what gauge speaker wire should I go with? Thanks, Voce.

Will do.

Thanks man, amp is on it's way. Will be putting in an order for a Fi Q 12" in a few days. This being my first setup I'm so stoked lol.

Hi, I'm looking at picking up a Sundown Audio SAX-1200D to match it up with a single Fi Q 12" with plans to run a ported setup. Being new to car audio my question is, will these two work together? Everything I've read seems to put these as a perfect match up. For options on the speaker I'm assuming it will need Dual 2 Ohm and cooling options. Is the option for an extra "spider" needed? I'll be ordering the amp in the morning, should you guys give the OK, as there is an amazing deal on one of the internet retailers. Thanks for the help.