USAMPFREAK

The 12 incher

Matt we do have a few dealers in PA what part are you in? TEAM NUTZ TECHNOLOGY 3635 LIBRARY RD. PITTSBURG, PA 15234 (412) 882-8346 ALL THE EXTRAS 2500 N. BROAD ST. PHILADELPHIA, PA 19132-4013 (215) 783-0925 That's all I can think of at this point.

The USA-2000X does 2000++ wrms @ 4 ohms mono and it may be because your lights are not coming back up that you are not noticing them flicker like the Alpine. With out testing the system personally all I can really do is speculate.

These are 750 rms so unless you kept the gains at a reasonable level you could destroy them pretty quickly.

Sneak peek of the 15's

I recommend from 650-800 watts rms each.

Revc= 4.000 ohms Levc= 1.33 mH Fo= 24.684 Hz Sd= 480 cm squared Md= 114.000 g BL= 19.709 TM Qms= 1.979 Qes= 0.522 Qts= 0.413 No= 0.116% SPLo= 13579.0 Vas= 41.598 Ltr Cms= 127.147micro M/N Mms= 326.975 g Mmd 320.928 g

I can tell you that it was done with a non-inductive load and it was actually a 0.9 ohm load.

JJ those parts are no longer being produced. however I can get you to the specs on that amp. just as soon as I scan in the old white papers.

Thanks All! I will try my best to give the most accurate info I have at the time of the post. Also my "story" will not change everytime.

Accordman you have seen me on Steve's forum for the longest time. I always give the most honest reply no matter how bad it hurts.

I have now had to go out side normal channels but He is getting his RA# shortly. I find it very very funny that he can blame US Amps for Ike Sounds short comings. But any ways. I sent the email to this guy and all he wants to do is blame the manufacter for someone elses errors.

If you are looking for that old school sound I would Look at the AX2000's they are built to the same standards as the old florida amps.

3- 25 amp fuses

no surface mount parts so everything can be hand place

Already taken care of

What Part of hand built is soooooo hard to understand shawn?????????