basshead7890

This fiberglassing stuff is hard a hell and I haven't even got to the actual fiberglassing.

Got metered again today and here are the results 33hz tone at the headrest with drivers door open 33hz tone at the headrest both with drivers side front door and rear door open and trunk open 33hz tone at the headrest both drivers side front door and rear door open & passenger side door braced and trunk open 33hz tone on the dash with both drivers side front door and rear door open and trunk open 33hz tone sealed on the dash 33hz tone in the kick with both drivers side front door and rear door open and trunk open & passenger side door braced and trunk open On music at the head rest both drivers side front door and rear door open and trunk open music at the head rest with both drivers side front door and rear door open and trunk open

I got a Nook Hd+ so now I'm going to start my first fiberglass project. Hopefully it won't be to bad

I sold it

http://www.ebay.com/itm/48-W-by-the-foot-BLACK-Fabric-Velcro-Receptive-wall-decor-covering-carpet-/280774295781?pt=LH_DefaultDomain_0&hash=item415f73c0e5

hope no one laughs at me but here is what i did. i just cut some peal and seal and just built it up, water doesn't get in either. i tried foam but didn't help.

now i have to raise up the sax, it's about .25" shorter then the saz and get some carpet

cool man, next time your in huntsville let me know

update:the alternator didn't fit, found out it was made for a civic, but I did get my other amp installed. I will finish up the cover panel tomorrow now im going to save up for another alternator and box

i just got a used mechman 220amp

Let me rephrase my last comment, It was effective in my install and I would buy again or recommend to somebody else. Also the top constraint layer doesn't cut your hand up either. The adhesive is strong and from my understanding it is thickest on the market at 87 and 90mils. I'm a noob and just trying to help.

it's great, thick and sticky

Got some of the murdermat installed. great stuff, sticky and thick

The dc is louder to the ear and on the meter by 2db, measured at the headrest both at 37hz. The most notable difference is the higher bass notes like around 45hz & up, it's like more of a punch in the chest and it's hard for me to explain, but xcon sounded deeper on the lower bass notes like around like 30hz and below. There really aren't any cons, just that the xcon wasn't the type of sub I wanted, I'm more of the spl type.

amp isn't for sale anymore

1. Product: Sundown SAZ-1500Dv.2 2. Specs: Rated power output ----RMS power, 2 ohm linkable/dual mono 3000W x 1CH ----RMS power, 1 ohm mono 1500W x 1CH ----RMS power, 2 ohm mono 800W x 1CH ----RMS power, 4 ohm mono 400W x 1CH Signal to Noise Ratio >90dB Low pass frequency crossover 35Hz~300Hz Subsonic filter 10Hz~60Hz Bass boost @ 45Hz 0~18dB Phase shift control 0~180 degree Frequency response 10Hz~350Hz (+/- 1dB) T.H.D @ 4 ohm <0.1% Efficiency @ 4 ohm 86% Fuse rating 40A x 4 Input Sensitivity 200mV to 6V (+/- 5%) Dimensions 252(W) x 58(H) x 434(L)mm 3. Description/Condition: Has a couple of scratches, about a 8/10 cosmetically, Mechanically 10/10. Amp includes original box as well as bass knob. Bought it, but now I have decided to go a different route. 4. Price: : $325 shipped No trades 5. Pictures: ** DO NOT DELETE ANYTHING BELOW THIS LINE OR THREAD WILL BE DELETED ** ----------------------------------------------- This message is automatically inserted in all classified threads. Please be advised, all buyers and sellers should satisfy themselves that the other party is genuine by providing the following via PM to each other after negotiations are complete and prior to dispatching goods and making payment: 1) Telephone number. Call the number back at a unspecified time and make sure that it is the person's correct phone number. 2) Name and address including postal code 3) Valid e-mail address. Send an e-mail requesting a response to information about the deal being made. DO NOT proceed with a deal until you are completely satisfied with all details being correct. It's in your best interest to check out these details yourself. If transaction was completed on ****, please use iTrader to record feedback. Potential buyers/seller should check iTrader feedback also before continuing transaction.

I want a Zcon but I just like the look of the inverted dust cap and Aaron said the zcon can't use them, so hopefully if ssa comes out with another sub it will have it.

I was one of the winners in MurderMat's giveaway and I just got it today, should have it installed later this week.

$300 shipped to lower 48

the 145 on the dash with xcon was with door open