wolf227

kenwood kdc x889 4.5 volts t 8004 fosgate t series component set 5.25 some old pioneer 6 * 9's t 1000 t1 d2 12 2.5 cubic ft @ 37 hz

kenwood kdc x889 4.5 volts fosgate t 8004

If the gain was down any lower, then i would hear little to nothing. Gain halfway on amp, gain halfway on head unit, no bass remote

Ok, you wanna call me a dumbass, but you still give no recommendation. I'm looking for help, can you do that?

Well with a dumbass like you behind the volume knob, no they aren't that tough. You are clipping the signal which is why the T1 is messing up, if you clip the signal to an Fi it will have the same result. And the gain isn't a volume knob, it is meant to match the input voltage of the amp to the output voltage of the radio's RCA's. So more then likely, after 1/2 gain, all your doing is clipping the signal harder and harder.

Are you kidding me? Gain half way and under 2000 watts. Tech specs: under 2000 watts for an fi bl. I figure I can unleash a little bit more power out this amp at three quarters on the gain. I am going easy on this t1. There is no way i'm abusing the system. I recall back in the day when I had a power 800 a 2 running two hx2's and watching the excursing stretch the rubber FLAT! i beat those subs up every day and had no problem. The gain was a hair from all the way up. You seriously believe that my t 1000 can blow up an fi bl. Please tell me they are tougher than that.

Ok, I have a fosgate t bd 1000 and I am ready to trade in my t1 for an fi. The birth certificate reads 1674 watts @ 1 ohm, and I believe that is true to the fullest. My gain is a hair over half way and the t1 is stiff and on the brink of freezing up. I would like to know which fi sub can I get the most performance out of off my amp. I plan to utilize the same enclosure which is 2.5 cubic ft and tuned to 37 hz. If not satisfied with the enclosure I will replace it with the recommended tech specs. Which sub would be the best match for the amp. I like it low and loud.