sefugi

Looking forward to this one!! Suspension mods?? I should say so! Bring it on!!

That is one sweet ride! Great place to get some great info on your ideas for sound!

Very Nice!!!

Twins!!! Nice!!! You gonna do that t-belt yourself?? Not that hard. Good work on the MPG!

Understand the getting reaquainted with the brands, had that issue a year ago when I joined the SSA forum. Lots of great info here. Enjoy!!

I think I saw that episode were at the end he built a tower of cereal boxes. That is some serious coupon dedication!!

Yes. Mechanically power handling will be down slightly due to the softer spider... but in box still easily 400+

Really nice unit! Bassaholic covered your questions. Here is a vid of the relay bypass how to if you need it:

That was some serious cutting!! Tuned in!!

Will the power rating and box sizes be the same for these as the V1's?

^^^This!!

Beautiful work on the buss bar setup!! Waitin' for more! Seems now a days it only takes a few criminals to make life(freedom) difficult for the law abiding.

8 gauge can be used for subs but depending on your wiring configuation it can be difficult to get 2 runs into one connector on the sub. 10 - 12 gauge is fine for most setups. I would say that you will have about 20' left over out of 50' of 1/0 doing a normal install w/ the big 3 unless you go around the rear bumper getting to the amp.

Lookin" so Sweet!!

Nothing better than big sound in a little car!!

Looking at the wiring on your battery you may want to check out this thread, it's a good read and very usefull info. Keep it coming.

Extremely Nice Work!!! The plan with the slot between the mounting plate for the amp wires = I am ing the continued attention to detail! More Please!

Nice Setup! Really Clean!

Wiring looks good, but that header looks GREAT!!

Show us a build log for those 2 ICONS when you get them! Sorry bout the theft, that **it always sucks.

You wanted clean and you delivered!! Very Nice!! Looking forward to seeing the bussbars mounted.

Door panel is pure sex, do you mind if I have a smoke? Awesome work!!

Looking forward to your build.

Not hundred percent sure, I know I can do screws from behind the door panels into the speaker baffle area. As for the left side where it's fb and no wood, perhaps lay down some two part epoxy? Any tips? I'm going to see how well this one fits on the panel, if it's close I'll finish it up, if not I may just make a new baffle and start over again If you are able to reach down into the pod, possibly nut&bolt to panel with a large washer on each side?