gcs8

dam is all i can say.

well everything is already installed in my ride but ill do a lil build log on the box and pics of it installed woot

ty ty, after i redo my trunk and get my new 1/0 wire in i will post pics and maybe a vid if my camera is not failing.

i wouldn't trade my SAZ-3000D for my left nut.

probably. 1500w is too much for a Q. the cooling should add 200-500 watts of power handling and it will still be set at -1db to -3db on the sub channel after its all set and done, and i can control my use of the vol knob.

the Q will be just fine. don't be so negative.

at 2 ohm's, also has cooling and spider.

i just hope the new setup is going to be as loud as my old set up.

dc resistance != impedance your final load is two ohms TY thats the answer i was looking for. sundownz told me to ignore that and just treat it as 2 ohm's. Your nominal load is 2 ohms... the 1.5 is your DC load which is not important. - Jacob ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ << his reply to my stupidity.

that is the cutest little sub, are you going to have a build log?

ty ty

its so stiff right now i can barely move it with my hand, the coils on the dmm read .7 ohm's and .5 ohm's. regardless of how i wire the VC's it ends up at .5 ohm's, not sure if its my dmm failing or if i just fail at life, any help? final ohm load should be 2ohms FI says .7 ohm's for D1 set so it should be ~1.4-1.5 ohm's

I don't need the wireing dieagram..... and the FI Q has .75 per coil so it does come out to 1.5 not 2.

Seting the gain, I run a saz-3000d just got a FI Q D1 wired in series, it comes out to 1.5 ohm load, there is no info for this ohm load for this amp.

^this config seems to work. i may have been in the mind set of septate subs. sorry for noobing up the place.

or this?

yes dual 1ohm coils. works fine one coil at a time or in parallel. but i can not run at .5 ohms.

and you mean like this? this has the same problem

its hooked up like in pic 2. Subwoofer Wiring Diagrams, One 1 ohm Dual Voice Coil (DVC) Speaker there is no third wire. main pos in one coil then main neg in the other but i have also tried main pos and neg in one coil set then jumper wires to the second coil.

if u want i can make a video of testing it.

as per your request.

this thread needed some pics i have more if you want them but hears the basics.

yep now i just haft to figger out what this all means. i should have gone in to electrical engineering instead of network systems admin.

and the coils look like there wired like there suppose to be.

well after more screwing around with it, and a battery. hear are my findings. parallel = ok series = fail