DD9915D!!!

A few more...

Drilling the facia in from the bottom

A few more Wiley brought over a dremel, nice tool, for routing holes. (Going reeeeally slow!) Test fit.. Poor shipping carton... 2 of the 3 top facias

here we go Here you go. more to come Later

Girls would sit on the bumper and thier hair would go everywhere.

Welcome!

x3 or 4 or...

Even better

Termpro had a thread that got stickyd a few years ago. most popullar cars and thist resonant freq, do a search there maybe Am I allowed to mention Termpro?

Chop, anything free is worth saving up for. lol!

Well duh, lights under your car give you more horsepower. So does a massive fin from a Gen IV Supra, maybe thats in the mail..... Looks recent, expires in 10. Perhaps the driver is infinitely baffled, omg thats sounds cool....

Gotcha, I should have mentioned it was no cranked up a lot. Extra grounds were pre-stamped 4AWG with eyelits from AutoZone, we got a crap load of them for $30. This was cheaper than another run of 0. OP - UNLESS you have done a laundry list of el-cheapo "up-grades" do not attempt to run a 2200D of a stock alt. Wedling Supply.com has a crap tom of 4, 3, 2, 1, 0, 0/1, 0/2, and 0/3 and is usually pretty reasonable on prices aside from ahipping in quantity, unless you live close. If you have an account with a car parts store like AutoZone, you can score some sweet deals. A few of the ppl around here have salvaged chubby alts from old semis and school buses with some luck.

That was ftl. Guy would probably claim they are water-proof, lol. Emphasis on retarded here,

My bad I am trully sorry for misleading everyone, I was in fact mistaken. After review I see I was fully intent on mentioning the Crunch GP4000, I am sorry if this confused anyone. OP, my bad.

Effin sweet man. Please post more so we can all peep your trash!! I got an 18 sitting here with a tone gen and about 100W, wanna see a 1hz excusion vid? You can hear a lot of noise @ 1hz, but to whatch the flex is so cool. It's like live slowmotion. I have to set a roll of solder on the cone to show its not a vid effect. KEEP UP THE AWESOME WORK!!!

Sorry, forgot to mention the Eclipse. He did not care about elcetrical upgades and did not understand thier importance in his system. Yeah, he will be back in a few weeks asking why is amp popped like an M80 and looking to get a bigger amp, since it must have blown since it was too small, lol, and asking about this SAZ3000D like his buddy has...

Ok, since it's bash the newb, allow me this lowly rebuttle. The amp is set to about 1/4 gain The woofers are American Bass XFL12D4 in customs boxes built by me and I have no clue how to fabricate an enclosure, something about laminar flow and 1782 ft per sec and 1/8th space and all that jazz. The car is running a Kinetic 2000 about 8 inches from the AQ2200. All equipment mentioned thus far is mounted to paint matched board immediatly behind the rear seat. This set-up has been like this for close to a year. There are 8 grounds under the hood. There are 8 grounds in the rear of the car, 3 involve the seatbelt bolts on the floor. There is one run of 0AWG from front to back. The rules state S Q and S P L cannot be mentioned - ever. Thus rendering all data on here objectionable. Including these videos, neither of which car is mine, or yours for that matter. So why care if someone else scrathed thier car? (PS if you do care so much, there is a Nerf football shaped crack in the passenger side door, The hood has hail damage, and the front bumper shows yellow glas, and I try not to show that side.) This car is more than likey NOT pulling more than about 120A of current at its peak. IF the amplifier WAS set to pull more current than that - the 12s would pop. The headlight do not dim. What would you change about this set-up? I got blasted for running Bass Boost, so thats off, Bass on the deck is at -6. I should change my name to Permanent Newb or soomething.

They have the same board as the American Bass VFL 400 but the VFL uses cheaper parts so the rail voltage it lower. The Hifonics can run at .5 ohm all day with a nice fat supplemental battery and chubby Big 3 without running and upgraded alternator. However, you are inclined to run a pair of them. This may require more than the above mentioned current upgrades, seeing as how you will have the potentional current draw of 500A( 250 each amp) you should look at a larger alt as well as larger batteries. You will not be wasting your hard earned dollars on these amps. The newer boards do not get as hot as the 08 series and have up-graded the boards to such a degree, the 08s and the 10s do not share the same heatsinks. Futhermore, the amplifiers efficiency has been increased to such a degree, you can run the newer model of an amplifier of the same specs, (1608 vs 1610) and see the fuse size decrease but the output remain the same. Apply this to the 2610...

I have a 100 year old recipe for Biscuits & Gravy, I modified it for use with Bob Evans Sausage, the gravy comes out so think you can eat it with a fork. The Buffet at Golden Corral is awesome for bksft, when back home in MI, I have to gorge myself at Big Boy. Deep fried french toast sounds good, here in Indy the state fair wore ppl out on deep fried food, I think next year they will just deep fry a stick of butter and re-package it as a Twinkie.

I like Uber-Gauss, lol. So, I need a link to the rules...

Since this is being mentioned here and is it purely contextual, WHY can one not mention Sir Meeeede'? Also why can one not mention other forums on this forum?