Soapbox

The Owl wasn't wise until he read the book and found the key to the heart

where's the mods on this one

So have you conduced any testing on solder? I'm going to use 8awg power wire knu has got it cheep and would like to limit the connections as much as posiable. using your data from above 3 dual speakers would be 12 times. Your data beggs to question: What the results would be under a load? What the results would be using lugs on one end? What the results would be using bolt through box terminals?

I would have thought closer to 55. What's your goal?

Afterwards I guess bassahaulic handles her paperwork. It's a dirty job but he likes it.

You dont have to break your back to get one. Honest.

Congrats, it looks like you've rounded third base. SWEET

Here's some good reading links posted that don't sound like guesses. Keep in mind the current draw for the ohm load. It out lines every thing clearly. One note is the testing was for burps not daily music. I'm not sure if any of the posters prior to me even have the amp in question. With that said, I haven't finished my installation so I can't even give my experience yet; however, I have read every thing I could find for my build. Read the saz 1500 post and view all of the videos on the below links. These will give you the basic knowledge to answer your question. Saz 1500 and ohm loads SAZ-1500D POWER TESTING - SSA Car Audio Forum Electrical videos HIFONICS - Video Support Library These will give you a basic grasp to be able to answer your questions.

So it says February would that be beginning or latter of the month?

After all of my reading. I knew I had read most of the pile. But then Jacob pointed me this direction. Thanks. The Aveo and the Fit are in the same sub compact class. No worries. Soapbox

I doubt Jacob measured, so just take the cone body diameter plus 1/3 the width of the surround. Dude take time to read prior to commenting. Mr. Obvious, that is what I have been estimating. Since no one but Jacob knows I doubt it would be a problem to measure for a paying customer. I have little patience for disrespectful people. At the present time I have several enclosures in the design and building phase and I don't want to waste either my time or Jacobs.