SNIPER-92

i cannot wiat for kaotic enclosures to come ou.. i want won, it took me over 15 mines to right that through all of this nodding out i ddddddddddd[==== thoses dees are the result of my nodding lols

understatement... Heat is the devil to all electronics... there is nothing worse in the world than heat build up on a component no matter the task it is intended for.. Good luck with your situation holley... hopefully it is quick.. true ****

ok i guess thats what ill do, cant wait to get the new sub though.

any new suggestions??

the box is small, it is like 18x18x18, a cube. loud though, and my amp is set to bridge mono on lowpass mode crossed as 59hz. the dayton site has no box dementions, and im pretty shure the clip indicator is good because i hear no audible distortion untill the clip indicator is pretty much solid. under that its very clean.

oh yeah.. heres the sub http://www.parts-express.com/pe/showdetl.cfm?partnumber=295-468&source=googleps

the amp has clip indicators on it and they dont light up at all when the sub gets warm... i keep a close eye on it... i had the box already and im buying a 2nd 15 in a month or 2 so i just threw it in the box temporarily, and its a single vc 4ohm sub. this is where i bought the amp.. http://www.proaudiostar.com/crown-xls-2000-drivecore-stereo-power-amp.html

I love this amp, but there are two questions i have about it. I have it hooked up to a 15in dayton audio reference series RF 15", and this sub is 500w rms mind you, it is hooked up 4 ohms briged, for 2100w rms, and it just seems like it should have more power than it does. It gets really loud, and gets the sub warm if i let it, (only takes about 20-40secs full power, then it smells a little), but it just seems like that if it was doing rated power, the sub would just bottom out and blow in a matter of seconds, it is in too small of a box(about 2-3 cu ft, it needs 8-10 per sub, might be why it dont bottom out) do you guys think im getting full power out of this amp?? and if i am, do you think it will be stable at 2ohms briged, im getting another 15in dayton. some good car audio amps that are rated stable at 1ohm are fine at .5ohms, so i figure crown is supposed to be one of the best, maybe it will to..

post new pics when your done with the install bro, looking good, btw good choice on the amp

Forum is almost 2 yrs old but, i say the BTL shall have the edge on this one.

Go ported @ 32hz w/ aa 1 cuft box. Would sound nice.

If you have room for a 15" xcon, thats the way id go. And plus you can always upgrade your amp with that one, id personally put a sundown amp on it

You will be fine man, dd's aree strong subs man

You will be fine man, dd's aree strong subs man

i have been wanting to do the same thing to my kenwood jl-703's, thinkin about putting some sundown audio sa-12's in them lol, what do you think?