Leaderboard

For the money you cannot go wrong, and also for the record Mach5 is the bomb I am really happy with my IXL, even though the box is too small it hits hard and low and laughs at 1000watts, next setup will be two 12's or maybe 10's me thinks

IXL. Maple Leafs Beat The Shit Out Of Rice Anyday. Lmao.

I don't know, how many times are you going to keep repeating this incorrectly? I am interested to hear your technical explanation of how the voice coil will "break down over time and kill the sub." I bet you would also say to never run only one voice coil of a DVC sub, too, right? You say that the signal to the voice coils does not add together when wiring one channel to each voice coil, but what does bridging an amplifier do? Hint- It.............adds the left and right signals together!

Because You're Blind. 15" SSA XCON D2 Re 3.7 Fs 31.3 Qms 6.11 Qes .45 Qts .42 Mms 268 Vas 88.4 Sd 810 Bl 20.71 SPL 89.6 Xmax 31mm

the brace you showed would be a waste of time IMO. to add some db's try rounding all the corners on the inside of the box. you can do it with poster board, and just use fiberglass resin to put it in, I like that method it's simple and cheap. plus it adds strength to the enclosure, a lot more than those little braces.

thanks man.... when i first mounted the woofer, i left about 5 inches from the edge incase i wanted to cut it down to the 7.7. but i was unsure if i would be losing or gaining anything. i think i will do that tomarrow. do you think corner angle braces would be needed? like these -> https://www.hardwareworld.com/Zinc-Corner-Brace-115bc-3-x-3--4-inches-pEC0UCY.aspx instead of cutting, add a board inside to change the volume, try some 2 x 4"s to lower the box volume that way your not cutting the box down then figuring out that its not what you wanted, then youd have to rebuild or put some really good bracing if you wanted to put the piece you cut off back on....

fuck u go spank the monkey some where else